RE: [OT] Asterisk at home help + XAP integration

["Ian Lowe" <ianlowe@xxxxxxxxxxxxxxxxx>]

Asterisk at Home has xPL built in, not xAP.=20

If you have xAP bits and bobs already, I think there's a xAP module for
Asterisk (not quite sure about the mechanics of AAH vs Asterisk raw there)
=
-
I'm sure Patrick or Kevin mentioned that previously?

If you don't have an existing set of tools, have a look at xPL. (there's a
yahoo group over here: ukha_xpl@xxxxxxx )

Ian.

-----Original Message-----
From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf Of
christopher purves
Sent: 19 October 2005 10:43
To: ukha_d@xxxxxxx
Subject: [ukha_d] [OT] Asterisk at home help + XAP integration

Hi All,

Well I have finally installed *@home and as I know quite a few of you use
i=
t
I wanted comments on my master plan before I set out to check I'm not being
an idiot.

I have installed *@Home on a Dell =A399 server (TM) and that all seems
fine=
-
painless install.

I propose the following - use Linksys PAB2 adapters on all fixed analogue
phones in the house. Buy a sipura 3000 to connect in the POTS land line and
to plug an 'emergency' phone into - on a power fail a relay in the sipura
bridges the FXO and FXS ports so I can still use the emergency phone no
matter what.

I have a couple of sipgate numbers now - I was gonna use one for voice and
one for fax and route appropriately.

I think I simply need to enable XAP in the * config to get XAP messages ?

Does that make some kinda sense?

Ta
Chris