RE: Comfort homeseer plugin help

[Martin Wonders <martin.wonders@xxxxxxxxx>]

Sorry folks,

Solved the problem and will teach me to read the instructions first.
Just in case your curious: to set comfort outputs from homeseer, you don't
use the outputs directly
You use the output activation zone device followed by the output activation
state device.

Martin

-----Original Message-----
From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf Of
Martin Wonders
Sent: 02 October 2005 11:32
To: 'ukha_d@xxxxxxx'
Subject: [ukha_d] Comfort homeseer plugin help

Good Morning all,

I'm trying to get the homeseer  - comfort plug-in working and have a few
problems that I'm hoping someone can help me with.
I can't seem to get consistent communications between comfort and homeseer
i.e I've had homeseer detecting zone changes but it seems To be
intermittent, also I can't get homeseer to change the output states in
comfort. Am I missing something obvious?

Best Regards

Martin


====
This e-mail is intended solely for the addressee. It may contain private
and
confidential information. If you are not the intended addressee, please
take
no action based on it nor show a copy to anyone. Please reply to this
e-mail
to highlight the error. You should also be aware that all electronic mail
from, to, or within Northumbria University may be the subject of a request
under the Freedom of Information Act 2000 and related legislation, and
therefore may be required to be disclosed to third parties.
This e-mail and attachments have been scanned for viruses prior to leaving
Northumbria University. Northumbria University will not be liable for any
losses as a result of any viruses being passed on.



[Non-text portions of this message have been removed]