RE: AirCon - with no digital buttons !??

["Neil Ball" <neilball@xxxxxxxxxxxxxxx>]

Ahh, I see the problem!! Does your unit allow a remote room sensor to be
fitted? If so you could leave the unit on and in cooling mode and wire in a
resistor directly rather than the thermistor sensor. Switching between 2
fixed resistances will force the unit to run when needed as it will think
the room temp is either way above or way below setpoint - it's not too
difficult to find out the thermistor types used by the different
manufacturers, but you can only do this if the unit supports a remote room
sensor in the first place.



_____

From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf Of
Gareth Cook
Sent: 12 July 2005 16:45
To: ukha_d@xxxxxxx
Subject: Fw: [ukha_d] AirCon - with no digital buttons !??



I did have a HomeBase unit that has buttons and a digital display - only
problem was when you turn it on it reset to 24 degrees and no a/c.

If you know of a digital one that defaults to a/c and lowest temperature
then it's not a problem.

And yes I never intended to hack the a/c unit - just an x10 appliance
module for example.

G.

_____



[Non-text portions of this message have been removed]