The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Bathroom Towel Rail Sizing and control




Slightly off topic this one, but it does have relevance.

I am about to buy a new towel rail for the bathroom in the flat.  To
give the most towel hanging / warming space, I am looking at a 1720 *
600mm monster.  However, I'm concerned that the heat output will be too
much and the room will end up being way to warm.  Being a bathroom the
door is mainly shut, so the heating system thermostat in the hall won't
be aware of the high temp in the bathroom.  Does anyone know if the
standard rules for sizing rads to rooms also work for heated towel rails?

A solution may be to have a temperature control of the rad using some
kind of automated valve.  The flow to the valve could be kept at a
sensible level when the room isn't being used, but boosted after a
shower to help dry the room and the towels out...

Anyone else have a similar system to this?

Simon






UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.