The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Projector Screen Automation Advice Needed


  • Subject: Projector Screen Automation Advice Needed
  • From: "darren_karp2001" <darren@xxxxxxxxx>
  • Date: Sat, 01 Jan 2005 19:47:47 -0000



Hi and a very happy 2005 to everyone!

If like me your still tired and a little incoherent then please
excuse any typos in this post!

I have an InFocus ScreenPlay 4805 projector and a Projecta Cinema
Electrol screen. The projector has a 12v output which as I
understand it can be used to control a screen. The only thing is the
Projecta screen does not have any 12v input!

Is there any way I can safely integrate something which will enable
drop down / pull up of the screen when the projector is used? I
assume that I will need some form of relay, etc. Perhaps there is
already a device available. Projecta supply a switch and harness to
lower/raise the screen which I'd rather not install.

TIA
Darren






UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.