The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Geovision



Hi All

I am running a GV900 with 8 cameras all on motion sensing and it has been
working fine for over 6 months. I have 3 partitions on 2 disks with a
seperate system partition and 2 storage partitions.. I am running a xeon
system with a gig of memory (total overkill I know but it was cheap) and
all
it does is cctv...

The system is set to recycle and rebooted every 14 days with a registry
hack
for it to autologin.. All was fine until a couple of days ago when it
started to reboot every 10 mins or so and I started to lose signal to a
couple of the cameras even though they are fine... (I tested them with a
seperate monitor etc)

Anyone had similar probs as I am now pulling my hair out for a solution and
will completely rebuild if I cannot figure it..

TIA

Mark H..



UK Home Automation Meet 2004 - BOOK NOW!
http://www.ukha2004.com

http://www.automatedhome.co.uk

Member Offers - http://www.freeranger.co.uk/ukha

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.