The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Re: Interfacing With Ethernet




>From my reference design it uses an RJ45 connector with integrated
magnetics and a low pass filter (FB2022) for filtering and isolation. The
quoted figure is 1500 vrms which I assume is 15KV.

I didn't see the FB2022 on most of the designs but it is possible I have
jumped to conclusions. To check google on FB2022 and the datasheet is one
page.

Ian





Ant <ant@xxxxxxx>
To:       ukha_d@xxxxxxx
17/03/2004 00:45         cc:
Please respond to        Subject:  Re: [ukha_d] Re: Interfacing With
Ethernet
ukha_d






On Tuesday 16 March 2004 22:30, ian.bird@xxxxxxx wrote:
> I have noticed a lack of isolation on a lot of these boards that have
> popped out in this thread.

What's a good figure for isolation? The modtronix one quotes 15kV.

ant

--
/\/\
www.ant.org  ('')  www.ant.org
()
Megawatt Winged Avenger



UK Home Automation Meet 2004 - BOOK NOW!
http://www.ukha2004.com

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.