[Message Prev][Message
Next][Thread Prev][Thread Next][Message
Index][Thread Index]
Automating Wrought Iron Gates
Hi All
Has anybody automated their gates before? Mine are 6ft tall * 12ft wide
made
of wrought iron. Not sure of the exact weight of them but they were made
by
Cannock. I am trying to locate a motor that could open them and I have
thought about the motor being on an appliance module but was wondering if
there are any purpose made gates openers with X10 functionality built in,
Any ideas or recommendations for gate openers etc?
Regards
Anthony
********************************************************************
This email may contain information which is privileged or confidential. If
you are not the intended recipient of this email, please notify the sender
immediately and delete it without reading, copying, storing, forwarding or
disclosing its contents to any other person
Thank you
Check us out at http://www.btsyntegra.com
********************************************************************
[Non-text portions of this message have been removed]
UKHA_D Main Index |
UKHA_D Thread Index |
UKHA_D Home |
Archives Home
|