RE: IR Emitter for Comfort

["Dean Smith" <ukha@xxxxxxx>]

Response on the Comfort list was that I needed to make sure any IR Led had
the appropriate current limiting resistor.

Can anyone confirm if the Xantech emitters have the resisitor in the
emitter
or not ?

Thanks

Dean

-----Original Message-----
From: Dean Smith [mailto:ukha@xxxxxxx]
Sent: 07 September 2003 20:03
To: Ukha_D@Yahoogroups. Com
Subject: [ukha_d] IR Emitter for Comfort


The comfort manual suggests I can simply add an IR LED to a comfort ouput
to
allow comfort to transmit pre-learnt IR codes.

Anyone done this and comment how well it works and/or got a Farnell/Maplin
part no for a suitable LED.

Can I just use one of the emitters available for Xantech etc. (like these
>from
http://www.letsautomate.com/10063.cfm

The application I have in mind would only need to operate 1 device in
node0 - so no need for high power blasters or anything.

Deano



** UKHA2004 BE THERE! ** - start planning now.

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/