The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: RE: Re: Programming a Panasonic KX-TD816 PABX


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: New HA PC in a box


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: New HA PC in a box
  • From: "Marcus Warrington" <marcusw@xxxxxxx>
  • Date: Fri, 30 May 2003 10:28:52 +0100
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx


I'm sure someone's already answered this but..

To turn it on or off then momentarily short out pins 6 & 8
To reset it while its on short pins 5 & 7

Easiest way to do this is with a metal ballpoint pen, simply
touch the tip of the pen between the two pins (they are actually
physically next to each other even though they are not numerically)

Marcus


Doesn't seem to work.

Pins are like this:

Pin Signal Pin Signal
1 HDD LED
2 POWER(ACPI) LED
3 HDD LED
4 POWER(ACPI) LED
5 RESET SWITCH
6 POWER BUTTON
7 RESET SWITCH
8 POWER BUTTON
9 RSVD_DNU 10 KEY

Any ideas?

Cheers

Jonny

--- In ukha_d@xxxxxxx, Ant <ant@a...> wrote:
>
> Briefly short pin 5 to pin 7 on jumper J3. Same to turn it off.
Page 2-10 in
> the manual for info.
>
> ant


Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.