The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Composite Video



Video cabling is all 75 Ohm rather than 50 I believe. 50Ohm coax (RG58) is
used for coax networking IIRC???

Paul.



-----Original Message-----
From: Kevin Hawkins [mailto:lists@xxxxxxx]
Sent: 03 July 2003 13:43
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] Composite Video



Would strongly recommend against doing this - it is a travesty to have a
super display like a plasma driven by composite video - the difference
between (YUV and RGB) cf composite is huge. S-Video is much better than
composite too (although not up to RGB or even better component). I tried it
as the first signal into my new Panasonic Plasma and I was horrified at the
picture I got - and it was a good quality composite signal on a short
length
of video cable. Running over UHF coax is also a bad idea as this is 75ohm
impedance whereas video is 50ohm - which creates an impedance mismatch.

Trust me it would be worth the effort to go for a higher quality solution.



Kevin



-----Original Message-----
From: Rob Mouser [mailto:rmouser@xxxxxxx]
Sent: 03 July 2003 12:58
To: Ukha
Subject: [ukha_d] Composite Video



A couple of questions:



Has anyone run their plasma on composite and could comment on the
picture quality?

Can you run a composite feed across normal coax (Thinking retro fit
here.)?



Many thanks



Rob





[Non-text portions of this message have been removed]







Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.