Panel mount mains capable switch required for X10 instalation

["big_red_frog" <anthony.tod@xxxxxxx>]

Hi All,

The build moves on, and I am now looking into bespoke brushed
stainless steel face plates for 1 and 2 gang socket boxes. Where
they are populated with other uses than the normal mains sockets.

These will be for various combinations of network, coax, and speaker
connections along with the obvious mains and switches.

What I am having difficulty in locating are mains rated momentary
push switches for the driving of LD11's.

I would like something chrome or brushed steel and round, where I
can mount upto 6 in one double gang face plate. But bearing mind
that they have to be 230V rated, which is the difficult bit, I am
sure that the current is minimal with there use as a switching
source for the LD11's

I am not keen on the clipsal range, they all look a bit plastic to
me, so does anyone already out there have sourced a switch along the
lines of what I have described?

Might be able to start making them low volume commercially, if I
have any luck I will post images and costings...


UKHA 2004: 15th and 16th May 2004

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx