[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Re: Parallel 240V and cat5/coax
- To: ukha_d@xxxxxxx
- Subject: Re: Parallel 240V and cat5/coax
- From: "ukcueman" <ukcueman@xxxxxxx>
- Date: Wed, 03 Dec 2003 21:58:09 -0000
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
> Shouldnt be any problems at all.
Thanks Keith. I'll do my best to keep water, insects and rodents
where they belong :-)
> > > I have a 4 inch duct going out to my garage. Inside that are
separate
> > > ducts for other services - water, electricity, coax and
cat5.
To get
> > > the most cable in, I may also end up with some loose cat5 as
well -
> > > ie only inside the 4 inch duct.
> > >
> > > This will be a run of about 40 feet where everything will be
running
> > > parallel - no crossing at 90 degrees here - with cat5/coax
and
240V
> > > physically separated by a minimum of about half an inch. The
coax was
> > > going to be for security cameras that would be located on
the
garage
> > > and looking back at the house and drive.
> > >
> > > (1) Is the coax likely to be a bad idea, even with CT125?
Should I
> > > stick with cat5 technologies?
> > > (2) Should I use unshielded cat5, trusting in its properties
for
> > > avoiding interference, or go to shielded?
Home |
Main Index |
Thread Index
|