Re: Cat5 related regulations

["Paul Robinson" <ukcueman@xxxxxxx>]

Joist drilling should be avoided entirely. My builder put 2" timber on
top of all the joists so the
2" stuff will be cut for pipes and cable, leaving the joists
untouched. It also gives 2" to get over
the top of the steel joists (of which there are quite a lot).

Crossing mains cable should be minimal - and certainly only at 90 degrees.

I was just concerned about what the building inspector might have to say
when he sees my NZ.

Is this a non-issue?

Paul

----- Original Message -----
From: "Dean Barrett" <dean@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Wednesday, April 02, 2003 12:54 PM
Subject: RE: [ukha_d] Cat5 related regulations


> My recommendations are to ensure you dont pass CAT5 with mains through
same
> holes - cross at 90degrees where necessary.
>
> Other than that you should be ok.
>
> If you drill joists make sure you dont drill to close to top or bottom
so
> you dont spike the cable with nails etc.
>
>
>
> Dean.
>
>
>
>   -----Original Message-----
>   From: Paul Robinson [mailto:ukcueman@xxxxxxx]
>   Sent: 02 April 2003 12:44
>   To: ukha_d@xxxxxxx
>   Subject: [ukha_d] Cat5 related regulations
>
>
>   Are there any regulations that I need to be wary of when laying
cat5? At
> last count, I'm planning on 3km with 138 cat5 cables terminated in
node
> zero. (This does seem like an unreasonably high number though!)
>
>   I'm thinking of both electrical regulations (not sure if they can
apply to
> cat5 given its limited power capacity) and fire regulations in
particular.
>
>   NZ is going to be a loft area in my converted bungalow - most of the
first
> floor is living space, but there's an end part off my en-suite
bathroom.
> This will have floor boards, but currently no plans for insulating it.
(I'm
> a little concerned it may be too hot in summer for all the electronics
I
> don't yet own :-( so insulation may have to be added later)
>
>   Thanks,
>   Paul
>
>
>   [Non-text portions of this message have been removed]
>
>
>
>         Yahoo! Groups Sponsor
>               ADVERTISEMENT
>
>
>
>
>   http://www.automatedhome.co.uk
>   Post message: ukha_d@xxxxxxx
>   Subscribe:  ukha_d-subscribe@xxxxxxx
>   Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
>   List owner:  ukha_d-owner@xxxxxxx
>
>   Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
>
>
> [Non-text portions of this message have been removed]
>
>
>
>
> http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>