Unfortunately doesn't support anything beyond Raid 0+1...
Phil
> -----Original Message-----
> From: Mark McCall [mailto:Mark@xxxxxxx]
> Sent: 23 October 2002 09:06
> To: Ukha_D@Yahoogroups. Com
> Subject: [ukha_d] [OT] UltraATA133PCI RAID Controller - =A319.99
>
>
> http://www.maplin.co.uk/email.asp?userid=3DP1102&source=3Dimag=
e&it
> emid=3D55298
>
> Was =A344.99 now =A319.99
>
> RAID configurations protect your
s=
ystem from
> catastrophic disk failures and system down-time while
> doubling the data transfer rates of your hard disk drives.
> Breaks the 137GB barrier! Supports various types of large
> capacity hard disk drives.
> Achieves burst data transfer
rates=
up to 133MB/sec when
> connected to Ultra ATA/133 drives.
>
> =B7 Compliant with Ultra ATA/133
s=
pecification and PCI
> v2.2/v2. Plug-n-Play
> =B7 Full backward support for
Ultr=
a ATA/100/66/33 standards
> =B7 On-board flash BIOS for
future=
upgrade
> =B7 Connect up to 4 IDE hard
drive=
s
> =B7 RAID 0 (striping) interleaves
=
data across multiple
> hard disk drives, which increases
> disk system performance
dramatical=
ly
> =B7 RAID 1 (Mirroring)
simultaneou=
sly writes data to two
> hard drives for data redundancy
> =B7 RAID 0+1 (Mirroring +
Striping=
). Four hard drives are
> required for this mode
> =B7 Acts as a conventional
(non-RA=
ID) controller when not
> configured for RAID
> =B7 On-board BIOS supports
booting=
>from
> drive or stripe set
> =B7 Auto-detects drive types and
f=
ine tunes to the best
> performance for each
> =B7 Supports scatter/gather,
multi=
-threaded,
> multi-tasking and automatic FIFO threshold
> selection
> =B7 Provides two independent
Ultra=
ATA channels for
> faster data transfer
> =B7 Full support ACPI (Advanced
Co=
nfiguration and Power
> Interface) for advanced system
> power management
>
>
>
> ------------------------ Yahoo! Groups Sponsor
> ---------------------~--> Home Selling? Try Us!
> http://us.c=
lick.yahoo.com/QrPZMC/iTmEAA/jd3IAA> /IBOolB/TM
>
>
> --------------------------------------------------------------
> -------~->
> http://www.automatedhome.co.uk=
a>
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.ya=
hoo.com/group/UKHA_Grouplists/
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.