|
Hi All,
I have a problem with poor X10 reception.
I live in a moderatly sized detached bungalow
with
the Homeseer PC at one end up in the loft and the X10 units dotted around
the
house. The devices at the far end of the house often don't respond to
commands.
I also have an IR-X10 box at the far end of the house from the PC and this
can
control devices close by but the HA PC doesn't always see the commands in
full.
Homeseer shows in the log partial commands.
I have noticed an even greater loss of X10
commands
since installing a Smart-UPS. The CM12U is located about 3-4 metres of
cable
length away from the UPS.
Is there a device out there that I can get to
either prevent the UPS zapping the signals or to boost the X10 at the far
end of
the house. I need a solution fast as SWMBO is getting rather cheesed off
with
the lights not switching on at her command and I am rapidly loosing WAF on
this
one.
Regards
Dave...
For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
|