[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Connecting a PIR to HomeVision
- To: "UK HomeAutomation ListServer" <ukha_d@xxxxxxx>
- Subject: Connecting a PIR to HomeVision
- From: "Graham Kiff" <graham.kiff@xxxxxxx>
- Date: Sat, 12 Jan 2002 16:24:19 -0000
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
I electronics knowledge is worse than useless, so I need some help
connecting a PIR to Port-A on HomeVision.
I have the following:
1 x CLIP-1 PIR bought from LetsAutomate
1 x 12v DC Power supply
The PIR has 6 connectors, 2 power, 2 NC tamper and 2 NC movement detection.
I realise that -ve & +ve from the 12vDC go to the same connectors on
the PIR
(terminals 3 & 4). I assume then I also connect the -ve 12vDC to
HomeVision's Ground and the +ve 12vDC to HomeVision's Common. This is
where
I get stuck, I now have the 2 NC movement terminals (1 & 2), where to
these
go? - I know back to HomeVision, but 2 wires?
Many thanks
Graham
Home |
Main Index |
Thread Index
|