I seem to have an ongoing problem with a number of TM12U's - the ones
bought
from Homebase. They appear to lock up and not respond to RF signalling at
all.
Sometimes they don't respond to mains carried X10 either. Pressing the
ON/OFF
button on the front seems to restore them to correct operation. I seem to
remember a similar batch problem with the older 418Mhz units that were
recalled through HomeControls. Anyone else experiencing this ? I have at
least 3 that have this problem and several new unboxed ones to test.
This
is every unit so far.
I also have another very strange anomaly - any guesses at this ??? I have a
room with 3 lamp modules in it all set to the same unit and housecode (eg
C3)
and on the same ring. They all work fine in response to the C3 ON and C3
OFF
commands however whichever lamp module is plugged into a particular socket
turns itself off whenever >ANY< X10 OFF command is received on
that housecode (the unit code is not relevant). So say a C6 OFF will
switch OFF any of these (C3) modules if they are placed in that
particular socket. If they are placed in an adjacent socket they work
fine. Only a C3 ON command will turn the lamp back on - very very
strange.
Kevin
For
more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:
ukha_d-subscribe@xxxxxxx
Unsubscribe:
ukha_d-unsubscribe@xxxxxxx
List owner:
ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is
subject to the Yahoo! Terms of
Service.