RE: PIRs onto HV.

["Phil Harris" <phillip.harris1@xxxxxxx>]

Title: Message

> Is your power for the PIR's being supplied by the HomeVision controller ? - if so your solution is fine. 

 

I'm supplying the power for the PIR from a 12v Wall Wart PSU ... this has it's 0v line tied to HVs "GND" position on Port B. Does HV have a 9V output as if it does the PIR will run from 9V too? (Haven't looked too closely inside HV yet.)

 

Might go get a different PIR if these are so non-standard!

 

Cheers

 

Phil

Yahoo! Groups Sponsor

ADVERTISEMENT
<a href="http://rd.yahoo.com/M=168643.1620686.3205344.1261774/D=egroupweb/S=1705041992:HM/A=816901/R=5/*http://www.overstock.com/cgi-bin/d2.cgi?cid=12973" target="_blank"> <img src="javascript:void(0);" width=300 height=250 border=0></a>

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.