> You need to set the LD11's up as Leviton Dim in HS as they use
Extended
> commands. If you have it set to Standard DIM then HS sends 100% to
turn it
on.
Ah right. Thanks Vince.
I wish Homeseer would let devices inherit changes from the base device type
since now I have to go through and change them all individually :(
Might have to write my own software sooner rather than later :)
Mark.
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.