|
|
The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024
|
|
|
[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Re: Re: Home Vision Question
- To: <ukha_d@xxxxxxx>
- Subject: Re: Re: Home Vision Question
- From: "steve" <steve@xxxxxxx>
- Date: Tue, 7 Aug 2001 21:20:40 +0100
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- References: <9kpd1i+sq81@xxxxxxx>
- Reply-to: ukha_d@xxxxxxx
|
Would a relay not do
----- Original Message -----
Sent: Tuesday, August 07, 2001 7:46
PM
Subject: [ukha_d] Re: Home Vision
Question
I forgot to mention...
I orginally wanted to use
the
ViaAccess Proximity key system. I have
two that I bought from
Mike.
These however only give 12v when key is held up. Would be
great
if I
could invert that, so that 12v went through all the time, but when
the key was held up, it went to 0v.
Wonder if Keith has any
ideas
on that ?
thanks
g
--- In ukha_d@y..., geraint@a...
wrote:
> Not got a homevision or even played/seen one.
>
>
I have just got the first of my electronic locks for the doors...
>
> after all the messing around, I have left the standard five lever
> mortice locks in, but have now purchased electromagnetic ones for
> daytime convenience.
>
> The circuit takes 12v (via
transformer) to power the magnet, so I
was
> thinking the
easiest
way was to hook this into an Appliance Module,
> wether plug in or
Din
Rail, so that I could switch off the circuit
> thus allowing
entrance.
>
> Is there a way in Homevision to run a macro off
a
housecode ?
>
> Then I could send an x10 signal to turn off
the
appliance module,
but
> then say 5 seconds later it would turn
back
on again, thus securing
> the door.
>
> Thoughts ?
Other
ways maybe ?
>
> Regards
>
>
Geraint.
____________________________________
Automated
Home UK
http://www.automatedhome.co.uk
____________________________________
Post
message: ukha_d@xxxxxxx
Subscribe:
ukha_d-subscribe@xxxxxxx
Unsubscribe:
ukha_d-unsubscribe@xxxxxxx
List owner:
ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is
subject to the Yahoo! Terms of
Service.
| Yahoo! Groups
Sponsor |
;) |
|
____________________________________
Automated Home UK
http://www.automatedhome.co.uk
____________________________________
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
|
Home |
Main Index |
Thread Index
|
|