----- Original Message -----
Sent: Monday, August 06, 2001 4:40
PM
Subject: [ukha_d] Re: Networking HA
PC
> 2. I only intend
on
leaving PC1 running 24/7 but occasionally
would
> like to issue
X10
commands from PC2. Is it possible to "map" the
port to
>
which
my X10 controller is connected to on PC1 to let PC2 control
it? If
so
> how is this done?
Or look at using a piece of software
such
as Laplink or PC Anywhere
to connect to the other PC over your network
and
contol one from the
other.
You occasionally see full product
versions of these pieces of
software given away on PC mags, usually the
previous release but
perfectly fine for simple screen
control.
What
HA software are you using? - the simplest way of doing this that
springs
to mind is to use Homeseer and its built in web interface,
then you can
connect to it across your network and control that
way.
Regards
Daniel
____________________________________
Automated
Home UK
http://www.automatedhome.co.uk
____________________________________
Post
message: ukha_d@xxxxxxx
Subscribe:
ukha_d-subscribe@xxxxxxx
Unsubscribe:
ukha_d-unsubscribe@xxxxxxx
List owner:
ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is
subject to the Yahoo! Terms of
Service.