[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
RE: Consumer Units
- To: <ukha_d@xxxxxxx>
- Subject: RE: Consumer Units
- From: "Phil Harris" <phillip.harris1@xxxxxxx>
- Date: Tue, 5 Dec 2000 17:30:49 -0000
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
That wouldn't be a problem ... I wasn't planning on hooking them directly
to
the meter tails and they will be supplied by a dedicated MCB on my main
consumer unit ... I was just looking to try to avoid a "rats
nest" of cables
in there if possible.
Phil
-----Original Message-----
From: Keith Doxey [mailto:keith.doxey@xxxxxxx]
Sent: 05 December 2000 17:25
To: ukha_d
Subject: RE: [ukha_d] Consumer Units
NO NO NO !!!
The busbar is unfused and only isolated by the main switch.
Your DIN Modules MUST be fed from a suitably rated supply via an MCB.
Keith
> -----Original Message-----
> From: Phil Harris [mailto:phillip.harris1@xxxxxxx]
> Sent: 05 December 2000 17:13
> To: ukha_d@xxxxxxx
> Subject: RE: [ukha_d] Consumer Untis
>
>
> Can you get the modules to feed from the bus bars that are part of the
> enclosure when used as consumer units or do you have to hard wire each
> module?
>
> Phil
-------------------------- eGroups Sponsor -------------------------~-~>
eLerts
It's Easy. It's Fun. Best of All, it's Free!
http://click.egroups.com/1/9699/1/_/2065/_/976037438/
---------------------------------------------------------------------_->
Home |
Main Index |
Thread Index
|