[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Re: Vertical Blind control
- To: ukha_d@xxxxxxx
- Subject: Re: Vertical Blind control
- From: Andrew_Mowatt@xxxxxxx (Andrew
Mowatt)
- Date: Sat, 14 Aug 99 19:00:18 GMT
- Delivered-to: listsaver-egroups-ukha_d@xxxxxxx
- Mailing-list: contact ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
C> Can anyone advise of a small motor (limited movement) which can be
C> connected to my comfort output, relay or x10 which can be used to
C> rotate vertical slats from part open to close. The power needed would
C> be very minimal.
I was thinking about this myself. A suitable "gear wheel" that
accepts the
little balls on a string would be need to put on the end of a motor too.
I presume some of the blind agents should be able to supply something?
Something with a position sensor would be even cooler to allow for manual
over-ride.
-- Via DLG v1.27
/\ndy.
E-mail: andy@xxxxxxx, Fido: Andrew Mowatt 2:263/150
------------------------------------------------------------------------
eGroups.com home: http://www.egroups.com/group/ukha_d
http://www.egroups.com - Simplifying
group communications
Home |
Main Index |
Thread Index
|