[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
RE: OT: DIY advice
James
Have you thought of using clip on skirting boards and running
some cable behind these to minimise the amount of mess and
redecorating?
I have some and they look fine when painted.
scott
-----Original Message-----
From: James Hoye [mailto:james.hoye@xxxxxxx]
Sent: 20 November 2001 10:14
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] OT: DIY advice
> Anyhow does anyone have any advice on the best way to chisel out
chasings
> for cables in the wall - I have quite a lot to do - unfortunately
> we have a
> concrete floor
>
> I was wondering if an angle grinder or SDS chisel drill was the way to
go
> with these. - rather than a chisel and hammer!
If you don't mind clearing up VAST quantities of dust, then an angle
grinder
will be the quickest. Just cut two parallel grooves, and use a bolster (or
SDS+ drill and chisel) to remove the bit in the middle.
Otherwise, you could try drilling lots of holes along either side of the
channel and remove the middle bit as before - this will take longer though.
There are some SDS+ attachments that were mentioned on this list a week or
so ago for chasing walls. Look at http://www.screwfix.com/ and find
catalogue nos. 6724, 6606 and 5097. Someone bought one and I think
recommended it. I've just got a DeWalt SDS+ drill with rotary stop that's
sitting in the corner of the office, so I can't (yet) comment. Roll on the
weekend :)
http://www.home-automation.info/converting_single.htm
and
http://www.home-automation.info/new_socket.htm
give some information you
might find useful.
James H
For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Home |
Main Index |
Thread Index
|