The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

RE: [KAT5] KAT5 & Subwoofers


  • Subject: RE: [KAT5] KAT5 & Subwoofers
  • From: "Keith Doxey" <kat5users@xxxxxxxxxxx>
  • Date: Fri, 3 Sep 2004 09:38:19 +0100

> -----Original Message-----
> From: frostie2001uk [mailto:neil@xxxxxxx]
> Subject: [KAT5] KAT5 & Subwoofers
>
>
> Is it possible to take the subwoofer pre out from an amp say in a
> central location, lets call that node0 ;) and run that using cat5
&
> kat5 to the subs location???
>

Absolutely :-)

In fact, if your subwofer has a balanced XLR connector on it you can use
just a KAT5 TX and feed the balanced signal directly from the
KAT5---CAT5---SUB by connecting as follows

Using LEFT Channel of KAT5
BLUE/White  to XLR 2
WHITE/Blue  to XLR 3

Using RIGHT Channel of KAT5
GREEN/White  to XLR 2
WHITE/Green  to XLR 3

If your Sub only has an unbalanced Phono then you will still need a KAT5
RX.

Hope that helps

Keith




KAT5 Main Index | KAT5 Thread Index | KAT5 Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.