Re: How am I using CAT5 modules...

[Frank Mc Alinden]

Thanks Mark ,Paul.....

Frank

----- Original Message -----
From: "mark_harrison_uk2" <<a
href="/group/kat5-users/post?postID=XTb4-4TTwN9jf4WwD-MVx-IebsSUOUKdg9-pfcGdS2RaCEIxA8kS96rgorTyk6UIQACqVXh9Zak0rTFjRg">mph@a...</a>>
To: <<a
href="/group/kat5-users/post?postID=OMUug-eHV5I8qxiob4MX1jt8j9o5JNtOkJXRPZzub04_hj09VHJC9Xcq-CDPkfV2sjPlzfeh5tEYdrm-2bli4-uET3s">kat5-users@xxxxxxx</a>>
Sent: Friday, July 18, 2003 3:57 AM
Subject: [KAT5] How am I using CAT5 modules...


> I have had three uses. As I move the house around, they change, since
> I only have two pairs of modules :-)
>
> 1: BabyCam
>
> Purpose: Monitor of the sleeping baby
>
> Video only. Composite video camera feed from one of the "colour
in
> good light, LEDs so monochrome in poor light" trained at the
cot...
> displaying in TV in bedroom.
>
>
> 2: Rear speakers
>
> Purpose: To prevent long trailing speaker wire round the room.
>
> Two-channel audio only. Rear-channels out of processor, into KAT5 TX,
> into wall, out wall at back of room, into KAT5 RX, into power amp,
> into speakers.
>
>
> 3: Dressing room zone extension
>
> Purpose: Make sure that the dressing room and the master bedroom play
> the same music.
>
> Two-channel audio only. KAT5 TX plugged into "preamp out" of
master
> bedroom system. Into amp/speakers in the dressing room. Amp is on an
> X-10 appliance module, and comes on automatically when a PIR detects
> movement in the dressing room, and off a minute after it stops
> detecting movement (unless it re-detects in the meantime, if you see
> what I mean.)
>
> Hope this helps.
>
> Regards,
>
> Mark
>
>
>
> To unsubscribe from this group, send an email to:
> <a
href="/group/kat5-users/post?postID=rnu1pPIMt0Kqy1jWJGTqpYm3F3c_7-meGMQzZe0q3oDNQC9cQmXosIoKQegJZb7-x1FWZmIkYcU4UrGcWAzWQvo3DNGehN3Vki-7">kat5-users-unsubscribe@xxxxxxx</a>
>
>
>
> Your use of Yahoo! Groups is subject to <a href="http://docs.yahoo.com/info/terms/";>http://docs.yahoo.com/info/terms/</a>
>
>