RE: KAT5 Cases

[Keith Doxey]

Sure,

The existing cases are 35mm x 160mm x 90mm

I am looking for something about the same size and cost but the OTHER WAY
ROUND !

By that, I mean the orientation of the removeable panels. The ends of the
current boxes are the 35 x 90 faces, I need to be able to mount the
connectors on the 35 x 160 mm face.

The existing cases were chosen specifically because of the removeable end
panels which allow for easy machining of the connector plates. It also
means
that I can get loads of connector plates made in advance without having to
buy and store lots of cases.

To date the only cases I have found that have a removeable panel of the
size
I want tend to be about 200mm deep and cost 3 or 4 times the existing ones.

Keith

-----Original Message-----
From: Mark McCall [mailto:<a
href="/group/kat5-users/post?postID=wfCz4UyUFkczJaIpMNZFsV9mVbHO_AXBO3P39BEG1bbdilXAcFO7lW7IlPHV8Egzh9WEtOVEC3k">Mark@L...</a>]
Sent: 18 January 2003 10:25
To: <a
href="/group/kat5-users/post?postID=eSCcm3WlBD60jzlfEunbN0LXIjlhzwlPEfzpkYZ8VV_aqtkWMZthWeCksu5O2tfnMPXT9q3pY0pJ9w17BUEtXA2iGm0">kat5-users@xxxxxxx</a>
Subject: Re: [KAT5] KAT5 &amp; IR


Keith

Is it possible to give a set of requirements/dimensions for the case so
anyone here or on UKHA_D could help track one down?

Thanks

M