The UK Home Automation Archive

Archive Home
Group Home
Search Archive

Advanced Search

[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: KAT5 Cases

  • Subject: Re: KAT5 Cases
  • From: Frank Mc Alinden
  • Date: Sat, 18 Jan 2003 11:00:00 +0000

Hi Keith
i have a box here its removable plate is 30mm x 130mm and the box is
110mm deep.Have a look here ........
<a href="";></a>
I think i pay approx $6:00


----- Original Message -----
From: Keith Doxey
To: <a
Sent: Saturday, January 18, 2003 9:41 PM
Subject: RE: [KAT5] KAT5 Cases


The existing cases are 35mm x 160mm x 90mm

I am looking for something about the same size and cost but the OTHER WAY

By that, I mean the orientation of the removeable panels. The ends of the
current boxes are the 35 x 90 faces, I need to be able to mount the
connectors on the 35 x 160 mm face.

The existing cases were chosen specifically because of the removeable end
panels which allow for easy machining of the connector plates. It also
that I can get loads of connector plates made in advance without having to
buy and store lots of cases.

To date the only cases I have found that have a removeable panel of the
I want tend to be about 200mm deep and cost 3 or 4 times the existing ones.


-----Original Message-----
From: Mark McCall [mailto:<a
Sent: 18 January 2003 10:25
To: <a
Subject: Re: [KAT5] KAT5 &amp; IR


Is it possible to give a set of requirements/dimensions for the case so
anyone here or on UKHA_D could help track one down?



KAT5 Main Index | KAT5 Thread Index | KAT5 Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.