Re: Chattering Super Sockets

["echo" <shaw@xxxxxxx>]

Welcome to the world of X-10 quality.


"Robert Green" <ROBERT_GREEN1963@xxxxxxxxx> wrote in message
news:kYmdnYC1-5lvTq3bnZ2dnUVZ_tWhnZ2d@xxxxxxxxxx
> Bought a few used and new SR227 X-10 wall outlet modules.  Tested them
> separately before installing by hookup to a line cord.  All was well.
Wired
> them into a duplex outlet box at the end of a run, pigtailed together and
> they (I think it's only one, actually) started chattering.
>
> I've read X-10 appliance/wall socket module chattering is almost always
> considered a mechanical issue, but why would they test cleanly one by one
> and then chatter when in place?  This is without a load plugged in.  I
> tested with a floor lamp, although perhaps not without a load in place.
>
> One other difference is that they are installed face down in the basement
> ceiling but I can't see orientation having much to do with it.  They are
> also set to the same housecode, but that shouldn't matter much.  Happens
> with both an XTB boosted and unboosted mini-controller.  Hit ON and you
get
> four rapid clicks from the wallbox.
>
> Any thoughts?  I am going to have to unwire them (what a BITCH!!!!!)
unless
> putting a load on the units or some other easier fix makes the chatter
> vanish on its on.
>
> --
> Bobby G.
>
>
>