Re: IR Blasters?

[nobody@xxxxxxxxxxxx (Dave Houston)]

"Craig M. Armstrong" <upzqsse02@xxxxxxxxxxxxxx> wrote:

>I plan to use the 172-94 kit. There is already a line of coax going
>directly from room to room. The 291-00 will be placed on top of the
>remote TV (the modulated video signal goes directly there). The INJ94
>will also be in that room, placed between the coax and the input of
>the TV, the 291-00, and connected to the power supply. The CPL94B will
>be connected between the coax and the modulated RF output in the main
>room. There is an end table beside the couch directly facing all the
>equipment I want to control--about ten or twelve feet away. I want to
>set an IR emitter there that is strong enough to control all the
>equipment.

Ahh - I was misinterpreting which end the IR receiver was at. Based on this
diagram...

http://www.smarthome.com/includes/showimage2005.asp?img=/images/8197ndgm.gif

I doubt the unpowered coupler will be able to drive the dual Niles emitters
but, again, that's guesswork. Why don't you try asking Smarthome's support
people about this?

If you can solder, see...

     http://www.hometoys.com/tips/tips20.htm#Entry 7