Re: Motion Sensor on 3-Way

["John Grabowski" <jgrabows1@xxxxxxxxxxxxx>]

"BruceR" <razrbruce@xxxxxxxxxxxxxxx> wrote in message
news:46acd450$0$29685$4c368faf@xxxxxxxxxxxxxxxxx
> Use a standard 3 way at one location and a 3 way motion detector at the
> other. Smarthome has them in both white and ivory:
> http://www.smarthome.com/2523w.html.  For ivory change 2523w to 2523i.
> You should be able to orient one or the other to cover both areas but if
> not you can use a pair of these.


The 2523 is actually a single pole motion sensor that can get wired in
series with a 3-way switch.  A two gang box is required for this set-up.


>
> y.angelucci@xxxxxxxxx wrote:
> > I have the following setup:
> > (1) Light fixture at base of basement steps.
> > (2) Switch plate at the top of the steps
> > (3) Switch plate down in the basement area
> >
> > I want that:
> > (1) The light turn on by motion when the plane is broken at the top of
> > the steps
> > (2) The light goes off after set period
> > (3) The light goes on by motion when the plane is broken in the
> > downstairs area
> >
> > Can I install 2 Leviton (3-Way) switches to accomplish what I am
> > looking to accomplish?
> > If yes, can you make some wiring comments so that I am certain we wire
> > this one for proper functioning?
> >
> > If not, how else should this setup be wired?
> >
> > Thank you,
>
>