[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Momentary contact switch using Insteon?

Subject: Momentary contact switch using Insteon?
From: RickH <passport@xxxxxxxxxxxxxxxxxxxxx>
Date: Fri, 03 Aug 2007 08:33:19 -0700
Newsgroups: comp.home.automation

Can anyone explain how to create a momentary switch behavior using
Insteon?  Where if the user is physically holding down a button then
the lamp is lit, conversely, when the user lets go, the lamp goes
out.  The lamp should never light unless the button is held down,
conversely, the lamp should never go out while the button is being
held down.  IOW the lamp is normally off and only on while someone is
holding the button down.  Is this possible using any of the standard
Insteon products?

Follow-Ups:
- Re: Momentary contact switch using Insteon?
  - From: Dave Houston

Prev by Message: Re: How to set timers for z-wave devices
Next by Message: Re: Occupancy detection
Previous by thread: Re: How to set timers for z-wave devices
Next by thread: Re: Momentary contact switch using Insteon?
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home