X10 Controller Question

["Brian Staff" <brianstaffRemoveMe@xxxxxxxxxxxxxxx>]

I've been sent here from alt.home.repair<g>

Is it possible for an X10 "control box" to show (say, with an LED maybe)
whether a remote device is on/off or has been sent the on/off signal?

I would like to control my water heater re-circulating pump (or garage
drive-way lights) - devices I cannot normally see from inside the house.

I'm sure someone will just say "switch it on/off - then you will know" - but
the notification on the re-circulating pump is useful to know whether it has
been on or off, because it takes a few minutes for the water to get to the
shower.

Will "Insteon" solve my problem? or anything else?

Thanks for any suggestions.


--
Brian