Re: X10 collision problem

[nobody@xxxxxxxxxxxx (Dave Houston)]

You're not likely to get many useful suggestions unless you provide a lot
more detail about what hardware you have. What, specifically, do you mean by
"transmitter" and "receiver" Do you mean PLC devices or RF devices. What
triggers the colliding signals?

"Melquíades" <srsuarez@xxxxxxxxx> wrote:

>I have a lot of X10 transmiters an receivers connected on a house, with
>a CM11 controller.
>My problem is that I have detected that when a module is sending a
>signal (xej. A2 - ON), if other transmiter send other signal in that
>moment (xej. A3 - OFF) there is a collision on the line, and the
>signals don't transmit OK.
>Do you know how can I solve that conflict on my X10 installation?
>thanks!