Re: monitor ademco 20p events with cm11a?

[RT <Gofigure@xxxxxxxxx>]

Sorry for delay...Vacation time of  year....

I have my system fire on the following events:
AWAY,STAY, NIGHT activate
system deactivate
Page button
Motion detect main hallway
Gun Case open
Basement Motion
Front Door
Side Door
Basement Door

with the 20P, you can have up to 16 X10 codes assigned to events.

Using most any X10 control software you can monitor for these events
codes and then perform some duty in response, Homeseer is great for
this.

RT

On Sat, 20 Aug 2005 02:21:59 GMT, drk <ve4drk@xxxxxxxxxxxxxxxxxxxxx>
wrote:

>OK, thanks ... any insights into what I would look at programming in to
>have all events fire an x10 event?  or failing that, major events and
>such?  I seem to recall there being some kind of limitation on the
>number/type of events that can be fired off.
>I'm just looking at logging all that I can, so I'm looking at firing x10
>events for as much as I can then ...
>
>thanks again.
>
>Dan.
>
>RT wrote:
>> Yep, works great, I use it to trigger my home automation software to
>> call my cell phone or send sms messages regarding the status of the
>> alarm panel.
>>
>> RT
>>
>> On Fri, 19 Aug 2005 03:37:09 GMT, drk <ve4drk@xxxxxxxxxxxxxxxxxxxxx>
>> wrote:
>>
>>
>>>I'm wondering if it's possible and if anyone's done it .. I'm a bit of a
>>>noob here...
>>>
>>>I have an ademco 20p security system installed. I understand from the
>>>manual that I can have events triggered via the x10 interface.
>>>
>>>If I have a cm11a interface on my pc, is it possible to see all the
>>>"fired" events from the 20p panel so they can be logged?
>>>
>>>Thanks.
>>>
>>>Dan.
>>
>>