Measuring X10 Signal Strength.

[mike <spamme0@xxxxxxxxxxxx>]

I'd like to measure X10 signal strength to diagonse some intermitent
problems.
I found reference to the "fact" that there's a pin on the decoder chip
inside the controlled modules that has either the filtered signal or
some amplitude level indication.
But no details were given.
Before I start tearing apart modules for their tunable inductors to make
a filter for the scope...can someone expound on this indication?
Thanks, mike
--
Return address is VALID but some sites block emails
with links.  Delete this sig when replying.
.
Wanted, PCMCIA SCSI Card for HP m820 CDRW.
FS 500MHz Tek DSOscilloscope TDS540 Make Offer
Wanted 12" LCD for Compaq Armada 7770MT.
Bunch of stuff For Sale and Wanted at the link below.
MAKE THE OBVIOUS CHANGES TO THE LINK
ht<removethis>tp://www.geocities.com/SiliconValley/Monitor/4710/