[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Help with OnQ telcom wiring

Subject: Re: Help with OnQ telcom wiring
From: "Harlan" <jharlan@xxxxxxxx>
Date: 1 May 2005 18:12:49 -0700
Newsgroups: comp.home.automation
References: <1114989583.542319.44770@xxxxxxxxxxxxxxxxxxxxxxxxxxxx> <FTede.11572$J12.6815@xxxxxxxxxxxxxxxxxxxxxxxxxx>

It's an OnQ AnyPort design.  So, if I understand your question, I plug
the RJ11 for a phone into the wall jack that is an RJ45, CAT5e insert.
That is wired to a blue 4-pair cable which is inturn home-run to an OnQ
box where all 4 pair are punched into a single board that distributes
the 4-pair comming in from outside.

Does that answer your question?

Jim.

References:
- Help with OnQ telcom wiring
  - From: Harlan
- Re: Help with OnQ telcom wiring
  - From: Jack Ak

Prev by Message: Re: Need some antenna advice (for my CM15A, of course)
Next by Message: Re: fix for rr501 lockups?
Previous by thread: Re: Help with OnQ telcom wiring
Next by thread: Re: Connect sensors to a mobile phone
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home