[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Connect PIM-R to OmniLT

Subject: Re: Connect PIM-R to OmniLT
From: "Mark Thomas" <mrt@xxxxxxxxxxxxxx>
Date: 31 May 2005 12:03:24 -0700
Newsgroups: comp.home.automation
References: <eee07a85.0505290734.76cec0fb@xxxxxxxxxxxxxxxxxx>

oren levy wrote:
> Hi,
>
> I have OmniLT with 10A17-1 serial module. I connected the Omni
> to the X-10 and it works fine. I also bought the PIM-r. I installed
> the Upstart and saw the UPB network. Than- I disconnect the PIM-r
> and connected it directly to the OmniLt (to the serial module).
>
> unfortunatlly, the omni recognize the X-10 but didn't recognize the
> UPb devices.
>
> Any suggestions?

Since you have shown that it's not a problem with the UPB devices, you
should contact HAI (or the dealer). Also, since UPB support is brand
new, make sure you have the latest firmware (2.9).

References:
- Connect PIM-R to OmniLT
  - From: oren levy

Prev by Message: Re: weather clocks
Next by Message: Re: I have seen the error in my ways, I'm sorry
Previous by thread: Connect PIM-R to OmniLT
Next by thread: Newbie Advice needed
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home