[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Connect sensors to a mobile phone



Paul and Vinnie

Thanks for the response.  I have looked at the Jaycar kit and it will do the
job if you only want to turn switches on and off and receive alarms etc.
There are quite a few other SMS controllers available that will also do
this.  I was looking for a device to actually send data from the sensors.

Regards
Peter


"Vinnie" <vinced@xxxxxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:Pd4be.24249$5F3.1526@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Hi Pete,
> The kit from Jaycar will do exactly what you want to do.
>
>
> Send me an e-mail if you need a schematic and some advice on how to
control
> your pumps.
>
> I have done a similar project using the Jaycar kit as in Silicon Chip
> magazine.
>
> Regards
> Vinnie
>
>
> "Peter K" <nospam@xxxxxxxxxx> wrote in message
> news:426c437b@xxxxxxxxxxxxxxxxxxxx
> > I have a small farm that is located in an area with mobile phone
coverage.
> I
> > have installed some soil moisture and temperature sensors and have a
pump
> > and watering system. I would like to be able to receive readings from
the
> > sensors as SMS messages and then turn on/off the watering system from my
> > home about 150 km away, based on my decision about the dryness
conditions,
> > again by sending an SMS. I have seen a few SMS controllers (Jaycar, Dick
> > Smith etc.) but none seem to do what I want.  Any suggestions?
> >
> > Regards
> > Peter
> >
> >
>
>




comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home