Re: lawn sprinkler control unit repair

[pak <eckerpw@xxxxxxxxx>]

OK, got the valve box all cleaned out. There are 5 valves, each with a
colored wire and a black wire which I guess is the common. All the
connections in the valve box that were under dirt are just connected
with wire nuts, but all wires seem intact and still connected. The
fuse in the control box is blown.
The advice here  was to check all connections and then waterproof with
gel caps. Can some one explain how gel caps work or what I do with
them? are wire nuts sufficent for this application?
Also George suggested " measure that solenoid at the control box to
verify that the resistance is comparable to the other solenoids, I
think in the range of 20-50 ohms. (Put ohmeter between
common and valve when watering is not active.)

Could you explain that a little further? I assume all the control
valves are soleniod operated. Not sure how to measure soleniod at
control box. Am I looking to see if one of the valves has shorted out?
Need a little more qdvice on the trouble shooting path.

Thanks
Paul





On Sat, 23 Apr 2005 18:53:51 -0700, "AZ Woody" <Reply@xxxxxxxxxxxxxx>
wrote:

>I saw one (don't recall the brand) that would also go completely brain dead
>if the backup battery went bad.  But it sounds like you should clean out
>around the values as a first step...
>
>
>"pak" <eckerpw@xxxxxxxxx> wrote in message
>news:d0ll61hgdvlb5qoagpu3cft9r6jefkca31@xxxxxxxxxx
>> it's a Hydro Rain HR 6000-1, not sure how old
>>
>> On Sat, 23 Apr 2005 22:55:01 GMT, "Jack Ak" <akjack@xxxxxxxxxx> wrote:
>>
>> >What is broken?  A device model number might be needed along
>> >with failure symptoms.  My local OSH store carries parts
>> >for the Lawn Genie controller.
>> >
>> >"pak" <pak.ecker@xxxxxxxxxxx> wrote in message
>news:24gl61d0gcnnrpalfsb0m3jo7pf0alhmdh@xxxxxxxxxx
>> >> Wondering if this is the right group to ask questions about automatic
>> >> sprinkler system control unit repair?
>>
>>
>