[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]
Napco panel stuck in configuration mode?
Sorry if this shows up twice but the first post isn't visible so not sure if I
missed a step.
Yesterday I managed to lock myself out of my GEM-P1664 panel. As it sits now,
all of my kepads show "out of system" just like when you have the panel in
Configuration mode. I can even access the keypad configuration. But I cannot
get out of this mode. It's like the system is stuck in configuration mode. I
have moved the jumper back and forth and powered down the panel for a few
hours (battery disconnected as well). System remains in "out of system"
status.
I've always done the programming via the keypad (yes, I know that's brutal) as
I've never tracked down the Quickloader software. This weekend I was
troubleshooting something and thought it was due in part to using multiple
areas on the panel. I had two areas configured b/c I had disconnected zones
and wanted them sitting in Area 2 to keep the keypads from only showing the
disconnected zones. So I had all the functioning contacts sitting in Area 1
and the keypads in Area 1. So for troubleshooting I finished the disconnected
zones and moved everything to Area 1. I noticed the keypads still had the "1"
in the corner and thought I must have something lingering b/c I didn't think
keypads showed any area notation when you were running a single area setup.
This is where I botched it..... I went into the program for the keypads (1425
- 1430) and deleted the nib for the area. I had the 5 pads set to 1 but
noticed the default was blank so I deleted it. When I exited program mode my
kepads flipped over to "out of system" and I'm stuck now.
Is there a trick here that I'm missing? I don't want to start from scratch as
it's a fair amount of coding. I did grab a copy of QuickLoader and have a PCI
Mini getting shipped to me but I'm nervous that the software won't be able to
connect either if the system is in this hung state.
--
--
posted via
http://forums.cabling-design.com/security-physical/napco-panel-stuck-in-configuration-mode-65870-.htm
using Cabling-Design's Web, RSS and Social Media Interface to
alt.security.alarms and other telecom groups
alt.security.alarms Main Index |
alt.security.alarms Thread Index |
alt.security.alarms Home |
Archives Home