Re: Master Code Reset - Caddx NX-8

[ABLE1 <someone@xxxxxxxxxxx>]

On 2/8/2018 6:48 PM, Bob La Londe wrote:
> On 2/5/2018 9:01 PM, ABLE1 wrote:
>> On 2/5/2018 3:41 PM, georgengwerume1@xxxxxxxxx wrote:
>>> Hie. default go to programing code (9713)
>>> was changed by someone... I am failing now to program the panel...
>>> what can I do to reset the go to programing code back to 9713.
>>>
>>
>> The 9713 Installer Code was most likely changed by the
>> installer to protect the programming data from being
>> modified so that the customers security will not be
>> compromised at the worst possible time.
>>
>> There are some backdoor techno ways to do what you ask,"+$'s"
>> but, the simplest thing would be to just buy "-<$" a new fresh
>> NX-8V2 board and you will have your 9713 the way you want.
>>
>> That is assuming your are the "owner" of the system and
>> not somebody trying to find out how to be stupid.
>>
>> Besides, if you want "security" to be "security" why would
>> you think it should be a simple thing to circumvent??
>>
>> Can I assist further?? ..............  Maybe................
>> Will I, Nooooooooooooooooooo
>>
>> Good luck!!
>
> I liked the architecture of the NX8(E).  I don't know why I never
> installed more of them.  Were they one of those companies that finally
> got a good product and then sold out?  (I hated the old Ranger panels.)
> I really liked the expansion cabinets that powered all their own devices
> so expanding the system didn't overload it.  It made putting multiple
> buildings on a single system dead easy.
>
>
>

I agree Bob,
I can only hope that they don't go away anytime soon.
Or if there is a replacement, that it be backward compatible.
Of course UTC/GE will never listen to little ol' me.