Re: Fault in Motion Sensor

[RTS <gafa@xxxxxxxxxxxxx>]

On 12/24/2018 7:09 PM, Jack wrote:
> On 12/24/2018 4:58 PM, RTS wrote:
>> On 12/24/2018 6:32 PM, Jack wrote:
>>> I have an Ademco Lynxr panel with several sensors throughout my house. I
>>> have recently been getting a "fault" error on one of my motion sensors,
>>> which I believe is the Honeywell 5890pi. I am aware of the bypass option
>>> on my panel, and would like to stay away from this option if possible.
>>>
>>> I have changed the batteries to known good batteries, yet I'm still
>>> getting a fault on the panel in the same zone intermittently. Is this a
>>> sign that the sensor is dying or is it something else?
>>>
>> does the cover fit securely?
>> not loose or misaligned..
>> the tamper switch could be causing the fault message..
>>
> The cover is on secure and aligned properly. The fault message has gone
> away for now, but I'm not sure if it will stick.
>
I don't use the Lynx system but we do use the Vista 20P with RF sensors..
Usually troubles come from loose covers or low batteries...
but, hey, anything is possible with electronics...LOL

--

*Rocky T. Squirrel, esq.*