[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Radioncs 9112 lockcode



replying to mike, D wrote:
> mike wrote:
>
> replying to Logan, mike wrote:
> There is a back door LOCKOUT code for all BOSCH Radionics panels this
> code is
> only on the  firmware chip on the board it took me 20 years to figure
> out how
> this code works it is a back door code they can only be used if the
> panel is
> completely dead (CALL FOR SERVICE) on the keypad I have this code now
> obtained
> by reading the firmware chip programming mounts of looking at thousands
> of pages
> of numbers.
>
> P. S there is no way to default a Radionics panel
>
I have 3 separate 9000 Main Panels , two  9412G and one 7412G that are now
responding to RPS with 5017 invalid datalock . I have replaced the Li 3volt
battery in each .How can I save the $150 extortion fee Bosch now wants to
restore these already older control panels? Is the back door code the same for
all or specific to each (firmware chip) ?

--
posted via
http://forums.cabling-design.com/security-physical/radioncs-9112-lockcode-22845-.htm
using  Cabling-Design's Web, RSS and Social Media Interface to
alt.security.alarms and other  telecom  groups



alt.security.alarms Main Index | alt.security.alarms Thread Index | alt.security.alarms Home | Archives Home