Re: *97 reset

[NickMark <nmarkowitz@xxxxxxxxx>]

On Tuesday, December 31, 2013 5:38:01 PM UTC-5, leroyb wrote:
> I did a *97 reset on my Ademco Vista-10SE security system. I have all 5800
>
> wireless transmitters. I entered *22-2 for RF system. I then entered *24 for
>
> house ID +1 the*56 went to zone 10 I filled in all zone information  response
>
> code 10 input device RF 3 ,learn S/N yes tripped transmitter ding waited then
>
> tripped again. I did all zones same way .I did a *99 to go back to arm system,
>
> read out says ready to arm and green ready light is lit. I pressed * 2 to arm
>
> and it did not respond I then opened front door and it did not report on door.
>
> I then did a code + #+3 for sniffer it detected all the transmitters I then
>
> did a code +#+4 for go/no go test no response. The system is not connected to
>
> phone. Thanks for any help
>
>
>
> --
>
> posted via
>
> http://forums.cabling-design.com/security-physical/97-reset-63386-.htm
>
> using  Cabling-Design's Web, RSS and Social Media Interface to
>
> alt.security.alarms and other  telecom  groups

*97 deleted all info in panel  you must go back in and reprogramm all items