[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]
Re: Alarm system transformer + power supply (would both go bad at once?)
On Mon, 25 Nov 2013 08:41:54 -0800, doug wrote:
> You will need keypads to match the replacement board, the sensors should be
> OK although you may have to change the EOL resistors (if they are used).
>
> If you have any 2 wire smoke detectors you may have to check compatibility
> with the new panel.
I do have smoke alarms but don't know how they're wired.
Likewise, I have motion detectors and mostly hard-wired door/window
switches, but some are wireless (the repair ones mostly).
I called a few outfits today looking for the D2212B(LT) control board:
http://www.alarmhow.net/manuals/Radionics/D2212/
Apparently Bosch (who bought Radionics) won't sell to a consumer, so I'll
need to get the D2212B board from either a distributor or dealer.
They retail about $100 to $125 but they're almost all out of stock on
the web pages that I've found them listed.
If I buy a new board that is not the D2212B, am I to conclude I *must*
go with Bosch/Radionics since I do have wireless devices?
alt.security.alarms Main Index |
alt.security.alarms Thread Index |
alt.security.alarms Home |
Archives Home