[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Alarm system transformer + power supply (would both go bad at once?)



On Mon, 25 Nov 2013 14:54:56 -0700, Tony Hwang <dragon40@xxxxxxx>
wrote:

>Danny D'Amico wrote:
>> On Mon, 25 Nov 2013 08:41:54 -0800, doug wrote:
>>
>>> You will need keypads to match the replacement board, the sensors should be
>>> OK although you may have to change the EOL resistors (if they are used).
>>>
>>> If you have any 2 wire smoke detectors you may have to check compatibility
>>> with the new panel.
>>
>> I do have smoke alarms but don't know how they're wired.
>>
>> Likewise, I have motion detectors and mostly hard-wired door/window
>> switches, but some are wireless (the repair ones mostly).
>>
>> I called a few outfits today looking for the D2212B(LT) control board:
>>   http://www.alarmhow.net/manuals/Radionics/D2212/
>>
>> Apparently Bosch (who bought Radionics) won't sell to a consumer, so I'll
>> need to get the D2212B board from either a distributor or dealer.
>>
>> They retail about $100 to $125 but they're almost all out of stock on
>> the web pages that I've found them listed.
>>
>> If I buy a new board that is not the D2212B, am I to conclude I *must*
>> go with Bosch/Radionics since I do have wireless devices?
>>
>Hmmm,
>If the control board does not solve the problem, then what?

Um, call someone who knows what they're doing?



alt.security.alarms Main Index | alt.security.alarms Thread Index | alt.security.alarms Home | Archives Home