Re: GEMINI P3200 KEYPAD MESSAGE

[proguardsec@xxxxxxxxx]

=CE=A4=CE=B7 =CE=A4=CE=B5=CF=84=CE=AC=CF=81=CF=84=CE=B7, 12 =CE=A3=CE=B5=CF=
=80=CF=84=CE=B5=CE=BC=CE=B2=CF=81=CE=AF=CE=BF=CF=85 2012 6:17:33 =CE=BC.=CE=
=BC. UTC+3, =CE=BF =CF=87=CF=81=CE=AE=CF=83=CF=84=CE=B7=CF=82 Jim =CE=AD=CE=
=B3=CF=81=CE=B1=CF=88=CE=B5:
> On Wednesday, September 12, 2012 4:23:46 AM UTC-4, G. Morgan wrote:
>=20
> > proguard Wrote: >I made a cold start to the panel and after that i made=
 doownload. >Everything was ok. >I was downloading the panel which was in d=
isarm mode and after ending >download this message came up. >I took the pan=
el on the bench in order to find out what happens. >The keypad is in addres=
s 01. Of course i power cycle it but after the >panel boot up this msg came=
 up: >"Enter our code to access area" I used master security code, dealer >=
code, user code 1, user code 2, but still the same. >"Invalid access code, =
try again" It's the first time i saw this msg... If it's already on the ben=
ch and you solved the customer's problem by replacement, just default it an=
d start over. Keep as a spare when you get it sorted. Napco can tell you th=
e procedure for a master reset. So can at least 4 folks here if they are wi=
lling to post it. I think you have an area/KP conflict.
>=20
>=20
>=20
> You have to be able to get into programing in order to default the panel.

I had get into keypad programming with 11123 and the keypad address is ok. =
Its 01. To default the panel i think the only way is the cold start functio=
n inside the programming. I dont know if there is a hard way to reset it.