[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]
Re: FCI 7200 Fire Panel
On 09/02/2011 11:01 AM, James B wrote:
> On Feb 9, 12:58 am, Frank Kurz<t...@xxxxxxxxxxxxx> wrote:
>> On 08/02/2011 7:53 PM, James B wrote:
>>
>>
>>
>>
>>
>>> Does anyone here now how to run autoconfig on this panel? When I try
>>> to run it I get an "access denied" message. The 7200 program manual
>>> says to log in with the level 4 code to run the config program. I
>>> have done this, but once it starts the autoconfig about 2 seconds
>>> later it comes up with access denied.
>>
>>> One thing I noticed is the user codes are only 2 digits and the manual
>>> says they should be 6, so I think its a 7200 Micro control but im not
>>> sure. I contacted a local FCI dealer "the original installer" and
>>> they told me the panel is no longer made and they are not sure they
>>> have a tech that knows how to program it still. They did say they
>>> would send one out and quoted me 10 hours @135 per hour. I am only
>>> trying to add 1 monitor module to the system. The current system only
>>> has 5 points on it now. Needles to say the dealer isnt intrested in
>>> such a small task, or helping me out.
>>
>>> Can anyone tell me the correct procedure for running autoconifg?
>>
>>> James
>>
>> There are two possible scenarios here.
>>
>> 1. You haven't entered the correct password (which is weird because it
>> should boot you out immediately), or
>>
>> 2. You haven't followed the correct sequence to get into
>> auto-configure. Are you trying to enter programming from the SCU or do
>> you have a KDU/KDU-L?
>>
>> --
>> Frank Kurzwww.firetechs.net- Hide quoted text -
>>
>> - Show quoted text -
>
> Frank,
>
> It has a KDU, the only thing that is different is when I log in and
> it asks for a password. The book says it should say "Enter Password
> 000000" this one is saying "Enter Password 00". I enter the level 4
> password and it accepts it. I have tried a few wrong passwords on
> purpose and it rejects them immediately. The panel is not in alarm
> when I log in but it does have 1 trouble "Extra Point" this is the
> point I am tryiing to add.
>
> James
Level four password is 440000. The programming sequence is really
specific and straight forward. If you need the manual, I can send it to
you. Unless the password has been changed by the "installing company"
(which is not uncommon), you should be able to configure the system.
Give me a call later in the morning. I'll be in the office after 1100
hours (Pacific). The 800 number is at the bottom of every page on our
website.
--
Frank Kurz
www.firetechs.net
"Lady Astor: Winston, you are drunk.
Winston Churchill: Yes my dear, but you are ugly, and in the morning I
shall be sober."
alt.security.alarms Main Index |
alt.security.alarms Thread Index |
alt.security.alarms Home |
Archives Home